Wash eroding the paint?

Supported by (Turn Off)

Tagged: Army Painter, Fantasy, Vallejo, Wash

This topic has 5 replies, 5 voices, and was last updated 4 years, 11 months ago by guillotine.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
March 19, 2021 at 8:16 pm #1624698

peacefulwarrior
2936xp

1

Hi,

I just washed a Em4 monopose Orc miniature that I had painted with Army Painter and Vallejo paints. Remebered that I forgot to paint the spear so I only washed one miniature. Turns out that was lucky. The wash seem to have “burnt through” or eroded (I think thats a word in english) the paint where it should have pooled. And the wash turned white. The wash was Army Painter Strong Tone. The bottle had been upside down for a while since it was starting to run out.

Any one else have any experience of that? What went wrong?

March 19, 2021 at 8:26 pm #1624705

crazyredcoat
13642xp

0

If it had been unused for a while it could have been a bit of a separation going on. I’m not familiar with those particular brands of paint, personally, but I have had some strange things happen with other paints that I forgot to give a good shake after not using for a while. Someone with better knowledge of the paint range might be able to give some further advice, though.

March 20, 2021 at 11:51 pm #1624904

avernos
35426xp

0

I think CRC is right, it looks like the wash has separated and you’ve ended up with the medium pooling with no pigment. give it a stir or shake up and see if that fixes it.

The other factor that it could be is something similar to frosting with varnishes, in which case if you applied it while it was very humid or cold you can see “frosting” if you brush a bit of gloss varnish over the white (or oil – cooking oil will do) if it vanishes then it was due to the environment. But I’ve used AP for several years now and haven’t hit this issue myself yet.

March 21, 2021 at 8:45 am #1624970

peacefulwarrior
2936xp

0

Yeah, it probably has separated. I threw the bottle away, it was nearing its end anyway. Gave the Orc a repaint and opened a new bottle. The new one works fine.

Thanks for your input!

March 21, 2021 at 12:27 pm #1625051

torros
23841xp

0

Could be there is still release agent on the figure that means the primer hasn’t adhered properly and the wash is moving it

April 14, 2021 at 9:39 pm #1635940

guillotine
16070xp

0

I’ve had this happen with Vallejo washes. I’m pretty sure it’s separation as suggested above.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.