Grave Expectations (Terrainfest 2025)

When we play Mordheim at the club, it’s essential to have a number of the ruined buildings raised up on risers. So I’m going to make a number of risers for the graveyard too. The plan is for 2 bigger risers (as I have two squares of polystyrene packaging) and a number of smaller ‘ziggurats’ made from foam core. 

I won’t attach the various statues, mausoleums and gravestones to these for a couple of reasons. Primarily, it’ll help with storage (the bits projecting from the surface of the riser will likely get damaged or broken off) but also it will aid with modularity. 

I decided to make the stairs to the first bigger riser fixed and cut out a section from the centre of one edge. I flipped the piece that I removed and glued it back into the space, to form the basis of the stairs.

The next step was to add some stone texture to the sides. Frankly I haven’t the patience to cut out and glue hundreds of bricks from eva foam, so I used lengths of textured wallpaper. I did resort to some thin eva foam (some more recycled elephant masks)  for the corner stones to disguise the gaps left where strips of paper met. 

I decided the entrance to the steps needed to be decorated, and found that I’d fluked cutting a gap that matched the space for the gateway section of the GW kit. I hot glued this into place. It comes with a cross over the archway, which is the kind of thing that may get knocked off, so I wrapped a length of chain around the base a couple of times and super glued that into place in an attempt to add some strength.  I delimited the steps themselves with more gravestones. 

At this stage I dry fitted a few fence sections and mausoleums to see what everything looked like : pretty good. Although I noted they would easily get knocked off.

The surface of the riser needed some texture now, so I used powdered polyfilla and craft store acrylic mixed directly on the riser, then spread out. I then  decided that I somehow needed to magnetise the fences, as they would easily fall off the riser. I experimented with hot gluing pins along every edge, but that was pretty hopeless. I picked that off and went for some magnetic sheet cut into strips. It’s the kind of stuff you’re meant to print photos onto to stick on fridges (I imagine) and not very strong. I bought it in error, to use for magnetising my bases and it’s been hanging around for a year or two. I’m not convinced it will work here, but let’s see. 

I also added more thin eva foam (more party bag masks) cut up and glued with PVA  to make a path at the top of the stairs.

The ziggurats are three steps high. Each layer is made up of two sheets of foam board glued together, and slightly smaller than the last. I didn’t really plan the sizes, just played around with what seemed right and would give a step wide enough for a figure to stand on. Each of the layers has a textured wallpaper covering.