Washed UP, 1490 Doom diorama board #TerrainFest2025
Casting loot markers
Recourse caches are a core component of 1490 Doom, so I wanted a thematic marker for them, the obvious choice being treasure chests.
I have a lovely sculpted chest that was gifted along with some miniatures, perfect for this purpose. I was very pleased with the result, so I thought I would share the method I use.
I love Oyumaru, it’s quick, clean, and with a little care holds up to multiple recasts.
Removing the parts without damaging the mold is the toughest part. I use small eyelet screws to create handles, pre‑drilling the holes to prevent damage to the piece.
When casting a full sculpt like this, I roll the Oyumaru into a ball and remove excess water, which can become trapped and distort details. I press the piece into the ball while continuously working the sides to keep them as snug as possible. I achieve the best results by wrapping the Oyumaru over the bottom of the piece and trimming the excess with a sharp blade once it’s cured.
To remove the part, thread a paintbrush handle through the eyelet and grip it with one hand while gently pushing the Oyumaru away with the other hand.
I generally use Milliput for larger casts. I apply very small lumps with enough water to create a thick slurry and work around the sides of the mould, pushing into all the details before back‑filling the remaining cavity. I slightly underfill the mould and push material to the sides, creating a shallow bowl; this helps the finished piece sit flush on uneven surfaces.
After 15-20 minutes, once the surface has begun to cure, I poke a hole for the eyelet screw. The hole needs to match the diameter of the screw’s shaft and be a little deeper than the eyelet will be inserted. Once completely cured (4–6 hours), the eyelet can be gently screwed into the hole, every few turns I back the eyelet back out to remove any dislodged material. If the hole diameter is correct, it won’t dislodge much material inside the hole, this is the trick to prevent cracking. Once I found an appropriate poking device with the correct diameter, in my case an awl, I haven’t had a single failure with this technique



