War of the Flamin' Roses (Terrainfest 2025)
Drowning in the details
Okay, what terrain set would be complete without rivers? Fresh, back from a family (we are a family now, it is very exciting) holiday for a week, I thought it would be fun to knock this out quickly.
What an idiot.
I wanted to future proof this set, so that it could be easily used to larger and smaller games. This meant that at a minimum, it had to be able top go straight across a 6 foot table.
I ended up making:
- 9 straight sections (two of which have rough rocks for crossing)
- 2 small adapter sections (being a metric country, the sheet of EPVC I was using was just over 1cm short of 2 feet. so I made a small section so it could go straight across a 4 foot board, and a lsightly larger one so it could go across a 6 foot board)
- 4 90 degree turns, so you could make moats or some other man-made river course.
- 3 gentle turns (more natural, 3 because that is what fit evenly across the sheet I was using).
- 2 y-sections to split the river.
- 2 long dead ends and one short one
Crikey. All sections were measured and cut out, and then the edges bevelled with a Dremel. I then glued large rocks and cork rubble along the sides. I then used hardware store wall filler to make the slopes, and then dremeled them again once they were dry. After that, I airbrushed the slopes brown, and the water a few different shades of blue.
In the above step were two unexpected sources of additional work: making sure that slopes on the sides would match up evenly with all the other pieces once sanded (ugh) and making sure the deeper blue sections airbrushed in the river matched up in width at the ajoing ends, for the same reason (double ugh). I should probably have just let my mate 3D print me the river sections, but where is the fun in that.
Once that was all done, sprayed Sceneic cement, flock and then sealed it. Varnished the river with gloss varnish, and then poured over UV resin once the varnish hardened.
I find the UV torches never completely set UV resin, but luckily (?) Australia has that gigantic hole in the ozone layer right above us, so I have all the UV radiation I need! Lucky me. Anyway, outside next to the pool for a wee bit, and then job is done!
1 1/2 – 2 weeks all told. Not so quick.





