WARHAMMER QUEST: RE-CREATING MIDDLE-HAMMER'S FINEST DUNGEON CRAWLER

WARHAMMER QUEST: RE-CREATING MIDDLE-HAMMER'S FINEST DUNGEON CRAWLER

Supported by (Turn Off)

Project Entry by adamogelsby

Back to Project Blog

Next Entry >>

<< Previous Entry

DESIGNING THE BOARD SECTIONS: DOORWAYS

May 17, 2026

No Comments

The original door sections have slots for the card board sections to slide into, but I had to design them differently, with a lip to fit over but board section rim. I would have to create the in 2 halves, then glue them together later for the best quality print. I also had to stick to architectural forms - skulls are just a bit beyond my skills at the moment!

The original door sections have slots for the card board sections to slide into, but I had to design them differently, with a lip to fit over but board section rim. I would have to create the in 2 halves, then glue them together later for the best quality print. I also had to stick to architectural forms - skulls are just a bit beyond my skills at the moment!

DESIGNING THE BOARD SECTIONS: DOORWAYS

I had to do a few test prints with these to be sure they would work, then tweak the bases accordingly

I had to do a few test prints with these to be sure they would work, then tweak the bases accordingly

Supported by (Turn Off)

Subscribe

0 Comments

oldest

newest most voted

Inline Feedbacks

View all comments