Terrainfest 2025 - Crusading in the Trenches
First set of details
Due to both the board not quite being the width I needed, and my shoddy cutting skills, the board had several gaps in the joins. Fortunately I had a fairly large tub of pre-mixed plastering filler, so a healthy application fixed the majority of the issues there.
Next step was to start adding the built up dirt around the trench and crater edges. This was done using rolled up tin foil and a glue gun.
Halfway through this however, i remembered i wanted bunkers in the fortified trenches, so the gluing was put on hold whilst i made up the bunkers.
For the bunks, i simply cut some 1 inch wide strips out of foamboard to form the bunker sides, glued them with pva and pinned them in, then cut out a roof slab to simply stick on top. Nothing too spectacular, but they’ll do the job.
Afterwards i was able to continue applying the tin foil to the edges, allowing for space around where the bunkers will be.
I also started covering the bunkers using the same filler i used for the gap filling, just to give them some texture. Once its dried ill sand it down and hopefully it will have a bit of a concrete texture to it.
I have one more step to do before i can start applying some colour to the board. Again, due to my shoddy cutting skills, the edges where the boards butt up against each other are not squared up, so I’m left with large crevices at the joins.
Tomorrow I’m hoping to get to B&Q for some mdf strips which im planning on screwing onto those edges and fill in, so that i can get some nice smooth joins. I’m hoping to have some colour on the board by next weekend, or, at the very least, be in a position to get the colour on. I have the materials I need, just need to be patient and get the edges done first.











