Draconis: Spring Clean 2026 (Fallout) and Onward

Supported by (Turn Off)

Project Entry by draconis

Deathclaw!

June 5, 2026

Tutoring 0

Skill 0

Idea 0

No Comments

5th June 2026

Getting close to the end of the starter box now, just the Deathclaw and the bonus Zetan to go.

I knew I wanted to go with brown tones for the Deathclaw, and a light underbelly. The zentihal prime wasn’t quite right for that though.

I started out by laying down some Gore Grunta fur contrast all over, then blocked in the underbelly and other fleshy areas in a mid beige (Rawhide from Foundry). I then drybrushed the brown armour areas (although it went a little chalky) and built up lighter layers for the under belly using lighter rawhide shade, then adding in some Ivory.

Then I gave an all over Agrax wash, thinned for the light areas. I also then blocked in the base colours for sand, tarmac and tyre, and gave them an Agrax wash to mute them and tie it together.

I had also picked out the claws, horns and larger spines in black, so I followed with a very light drybrush of ivory (leaving a grey gradient).

Areas of the underbelly with highlighted on the upper sections and I added in the mouth (deep red), tongue (pink), teeth and eyes to bring the face to life.

A few added touches of orange to areas of the base, and some tufts, and the Deathclaw was done. Its not amazing, but it is done 😊