Kali Yuga: The Age of Conflict
Set into good hands
I’ve not been able to get my new photographer for the imagery here but I figure it would be good to have before the closing bell of the Spring Clean Challenge. I’ve gotten the figure done and I will say the swords are very frickin’ flimsy. This was modeled to be an 11″ model and not this small. I’ve managed to balance this out on an 80mm base. Another note for the size is these swords have busted off repeatedly and will likely keep doing so. I give up and I’ll just live with it.
Here I am very happy with the patina as it wasn’t too rich a spray using IPA and pigment powder. I think I’ll keep it and investigate what I can get done as far as a custom 3D print in metal. It would keep me from having to secure the hilts to the hands over and over again.
