Dead Man's Hand - The Baron Gang by Deltex
#UPDATE 2 - Basing & Priming
Once the miniatures had been printed, supports removed then cured, they were cleaned up using a modelling knife to get rid of any remaining support lumps.
Then using Super Glue Gel, attached the miniatures to the 28mm bases.
After that it was time to put basing material down, I used some normal (runny) superglue and spread it out across the base with a wooden toothpick.
I placed one or two small stones on the base to look like rocks, and sand was then carefully and slowly poured across the glue.
The first one I did too fast and the superglue soaked up into the sand and it clumped up.
Once I was happy it was all dry, Chaos Black Primer was sprayed all over the miniatures, then an hour later sprayed Wraithbone primer for a warm white at a top-down 45 degree angle.
